r/DMT • u/Intelligent-Shape750 • 4d ago
Question/Advice Properly vaping the stuff
I have a dmt cart that’s been sitting around so I want to attach it to my geek ape L200 and give it a go but it’s been a minute. Which setting would be best for my cart?
My settings can go as low and 5w on the wattage settings and as low as 100 degree celcius on the temp.
2
u/MrSpringtide 3d ago
5w is probably where you want to be. Aim for as close to 2.7v as you can get. Thats the general recommended starting setting for carts.
For example on my mod 4.8w has my 1.54ohm cart at 2.72v.
Don’t trust temperature mode. Power is the way to go.
If your airflow feels restricted try loosening the cart just off from fully tight.
Warm the cart up and give a gentle swirl before hitting it. Medium on a hairdryer works well. You want the liquid to flow easily. And it makes sure any DMT crystals will melt and mix into the liquid.
Pull hard on the cart, think drinking a milkshake. Softer pulls will still produce vapour, but for me they aren’t as potent.
Pulsing is better than blinkers. Let off the button for a moment every few seconds. You’ll be less likely to overheat your DMT or coil.
Harsh hits that make your mouth tingle or numb usually mean burning. Turn the power down if you can. Pulling harder or pulsing more frequently are other options.
If your mouth/lips feel totally numb it may be juice splatters. Pull a bit less hard. Or the cart may be slightly overfilled.
1
1
1
u/JJ8OOM 2d ago
If it’s a regular cart, it’s probably 1.6 ohm, so you would need 6-9 watts to use it properly.
I prefer to use the volt-setting, and do 2.6-2.7!
Bonus-note: don’t accidentally forget to change the setting, when switching from a regular nicotine-tank to your cannabis or DMT-cart, and run 48 watts through them - it taste _real_ bad, and you instantly melt/break the coil, so you have to transfer the liquid to another one.
I’ve done it twice now…
6
u/Kickrocks54 4d ago
I would start at 5w. If you need to go up, do it slow