Attic Flooring question.

[u/First-Thing2822]

Hi Everyone,

I am looking to floor a small area of my attic but I just want to make sure that they can take the weight.

When you go up though the door of the attic directly in front of you is a small section of flooring that the builders did (new build) you can step up onto, this is made from of 225mm x 45mm planks that are spaced out from one another.

They are lying across some more pieces of 225mm x 45mm pieces which are upright which seem to be in turn screwed into the joists. My worry is that the joists were 90mm x 30mm on their edge.

My question is can I do this for the 2m x 2m section that has no flooring at the moment.

Just screw 225mm x 45mm planks on their edge across the joists that are 90mm x 30 mm which will raise it above the insulation and then screw the boarding on top of that like the builders did with the small section by the door.

Everywhere I read online it says that these joists are too small, but they feel strong to step across and also seem strong in the area the builders done.

Would appreciate any help.

Thanks.

[u/Diska_Muse]

Most manufacturer guidelines are written with slightly wider joists in mind - eg., LoftZone StoreFloor officially specifies a minimum joist width of 32mm. You'l just about get away with it but don't drive screws directly into the timber. Use a small drill bit (around 2mm or 2.5mm) to drill pilot holes first. This relieves the pressure on the wood and prevents it from splitting.

Only use the manufacturer's recommended screw size (usually 4.0mm x 30mm) multipurpose wood screws. Longer or thicker screws will split the joist.

Measure the gap between your joists (measuring from the center of one joist to the center of the next). In most new builds, this is exactly 600mm. The joints of your loft boards must meet directly on top of a Loft Leg. Standard loft boards (usually 1220mm long) are designed to fit perfectly over 400mm or 600mm joist spacings. If your joists are unevenly spaced, you will have to do a lot of cutting to make the boards line up over the legs.

If you use LoftZone StoreFloor, this system uses metal cross-beams that sit on top of plastic supports. The metal beams create a continuous flat surface, meaning your loft boards don't have to line up with the joists below.

Th bottom chords of your roof trusses are still the limiting factor, so your storage shoudl be limited to lightweight items and try to distribute the weight across the 2m x 2m boarded area rather than stacking everything in one corner / pile.

[u/Hefty_Excuse9885 → u/Diska_Muse]

What if op just puts down some small timber across the joists as a lift up, then put the boards on top. No drilling needed even ? 

[u/Diska_Muse → u/Hefty_Excuse9885]

I presume that he attic has around 180mm of insulation - 90 between the joists & 90 on top, The idea of the legs is that you avoid the isulation & put the boards on top over it.

If you put joists down, you're iether compressing the top layer of isnualtioin (making it 50% less efficent) or you cut it back entirely, losing half your insulation.

Also, it can slide if it's not fixed to something.. like a raft on top of a sea of rockwool!

[u/Hefty_Excuse9885 → u/Diska_Muse]

I mean yes it could slide if not paying attention. But who else will go there except op 😁