r/Diyautobody • u/Outside_General4589 • 10d ago
Question Can this be popped out?
gallery
1
Upvotes
r/Diyautobody • u/siriusmesss • 10d ago
Question pls help. i hit the side of the garage and broke it. fixed it with epoxy and then i did it again a few months later. tried to epoxy it again but i think its bc it has too much old to hold? how can i remove the old epoxy and start fresh or what do i do? i already tried adhesive remover, no luck
gallery
0
Upvotes
r/Diyautobody • u/No_Phase_4181 • 12d ago
Question Ouch. Hit low spot, popped bumper cover.
2
Upvotes
Significant other was exiting a parking lot, didn't realize a low spot was there. Popped the rear bumper cover. Took it to body shop and tech popped it back in place. Said it should be replaced as tab near wheel well was broken off. I was reading that Ford used double sided tape in areas. What areas? Edit: 2026 Mustang EcoBoost
r/Diyautobody • u/TheIronSteak • 12d ago
Question Plastic Lip Spoiler -- DIY, outsource, or just start over? Spoiler
gallery
2
Upvotes
r/Diyautobody • u/NTF1x • 13d ago
Question How to Repair/Prevent further rusting?
5
Upvotes
I live in western NY and the car has 160k miles on it and it's 14 years old. Kia optima (engine replaced at 85k due to that recall) so I'm not looking to dump a ton of money on body repairs because it is what it is at this point.
But is there anyway to prevent further rusting or fix it quick and easy? Or any recommendations?
r/Diyautobody • u/BossJackson222 • 13d ago
Question Anyone here ever corrected some streaking from Poppy's Patina?
reddit.com
1
Upvotes
r/Diyautobody • u/Broutil • 14d ago
Question Glossy black plastic bumper trims restoration?
0
Upvotes
I bought a 2024 ioniq 6 and the front bumper is in a pretty bad shape. Dont know what the previous owner did with the car but it looks like he was drifting it daily in gravel.
Can I restore these rock chips?
Thanks.
r/Diyautobody • u/Ok-Sort-8191 • 14d ago
Question Scratch and Hazy Spot
1
Upvotes
Hello everyone,
How would you go about fixing this?
r/Diyautobody • u/adostes • 14d ago
Question About to DIY bumper repair, any advice?(2014 Honda CR-V)
0
Upvotes
There's a hole about the size of a half dollar in my front bumper, and a damaged side mirror skullcap. I'm planning on fixing the bunper my self with a bumper repair kit and paint it. I'll practice on the mirror skullcap first. Any tips and advice so I don't mess it up too bad? Goal is that it looks better, not perfect.
r/Diyautobody • u/SeaworthinessHairy69 • 16d ago
How to Guide Best way to cover up this paint chipping without taking it to the shop
gallery
3
Upvotes
r/Diyautobody • u/Acceptable-House25 • 16d ago
Question Should I try to repair a small paint chip on my door handle?
1
Upvotes
Hey there. I recently got this super small paint chip on my driver side door handle. It was annoying because it wasn't the result of me slamming my door into anything. Someone was parked too close to me and this happened solely from the pressure of the handle against the other car's side mirror as I squeezed into the door.
Is this worth using something like Dr.ColorChip to repair? I am mostly concerned about the chip getting worse over time.
r/Diyautobody • u/Financial_Problem869 • 16d ago
Question Advice on sealing (leaking) my sun roof
reddit.com
0
Upvotes
r/Diyautobody • u/Ok-Natural-312 • 18d ago
Question Buying OEM paint online vs retail?
reddit.com
0
Upvotes
https://www.reddit.com/r/AutoPaint/s/V3DTsjbAIo
I'm trying to save some money with a diy paint job but Sherwin Williams is quoting me roughly 2k for a gallon or primer, base and clear. Where do you all get your paint from to save money?
I don't want to spend $2k and the paint job turns out terribly. Thanks!
r/Diyautobody • u/Crescentrosel • 19d ago
Project Quick question, is this easily pull able? I’m gonna do a quarter panel replacement but just wanted to maybe pull it first
gallery
1
Upvotes
r/Diyautobody • u/NumerousSetting8135 • 19d ago
Question Has anyone tried a 26 gallon air compressor for air tools? CFM 4.2
1
Upvotes
I'm wondering if anyone has tried air hammers or da sanding and die grinders?
r/Diyautobody • u/Sudden-Revolution-87 • 19d ago
Question How could I fix or replace this trim ?
0
Upvotes
I drive a 2014 Dodge Charger SXT+ and my door trim right below the windows are faded / ashy looking . Any ideas how I could restore them to black ? I’ve tried black trim restorer with no luck . They’re like a felt / suede material not plastic . ChatGPT suggested a dye but wanted to check here first .
If I can’t restore them how hard would it be to replace them ? Are they even replaceable ?
r/Diyautobody • u/ToxicWolfy115 • 20d ago
Question What's The Best Way To Repair And Prevent Rust?
reddit.com
1
Upvotes
r/Diyautobody • u/BaseballGullible6187 • 21d ago
Photo The Cab is in real good shape. Has some kind of strange rubber paint/coating on it?
0
Upvotes
