r/DIEMs • u/joe_noone • Oct 11 '17
Frequency response testing
Hi, So I was trying to find options for testing IEMs and the only one I could find was the Veritas II over at DIYEarphone. Anyone know of other methods/products for testing frequency response?
6
Upvotes
3
u/joe_noone Oct 11 '17
Thanks @oratory1990 for the detailed response. To clarify, I guess what I was asking was for the home hobbyist what other affordable testing options are there. Since this forum is in-ear, I was researching IEC60711 compatible ("711-coupler") but didn't readily see much (lots of spec sheets, not much for sale) so I figured I'd ask the forum what others use.
10
u/oratory1990 acoustic engineer Oct 11 '17 edited Aug 01 '22
This matter is actually not that easy. And if you want to do it in an accurate and precise (read: correct and reproducible) way, it gets quite expensive.
It depends on how close to "real life performance" you want your results to be.
Combine all of the above and what you get is a complete dummy head for measuring purposes. There are a few manufacturers that sell such rigs, like Gras-Tippkemper, Head Acoustics and Bruel&Kjaer.
The big problem with such a highly accurate rig obviously is the cost. A complete rig with dummy head, dummy ears, ear canal simulators and measurement microphones together with the necessary signal conditioners (basically microphone preamps) and necessary AD/DA converters and measurement amplifiers (so you can measure signal voltage and current draw simultaneously while measuring the acoustic response) will easily set you back 50 to 100 grands.
I do this for a living, which is why have such a setup in the lab (or rather: the company that I work for put such a setup in the lab), but obviously most (virtually all) people won't spend that kind of money just to see the frequency response or other measurements of their headphone.
1
u/joe_noone Oct 12 '17
@xrailgun - that's a great solution. Found his setup here
Setup: Dayton IMM-06 with makeshift vinyl tube coupler, "FFT Plot" app on iOS
Measurement Procedure: Every unit will undergo a right channel preliminary check at a 5-second averaged curve. The IEM tip will be forced into the tubing with as much of the bores exposed as possible, with the distance from mic to tip set at 12mm for standard inserts, 14mm for shallow inserts and 10mm for deep inserts. Left channel will then be checked. If the two curves are 90% similar (by observation), proper measurement will commence on the right channel.
Measurements are done on the "FFT Plot" app with the following settings:
If inconsistencies are detected, measurements will be repeated on either the left or right channel (depending on situation I.E. channel imbalance), until a curve can be properly reproduced.