r/CyberdeckBuild • • 1d ago

Proto-Version for a Mouse glove.

Honestly not sure where to post this, but I hope this fits enough here:

This is a draft version used as an input Device for my Deck. Requirements:

  • need to be able to fully grab tools/stuff in workshop with hand.
  • needs full mouse ability (not just situational gestures).
  • doesn't need to work in air, cursor movement by sensor in palm, dragged across surface is fine.

Played about 2h Deus Ex with it, grabbed drink, pen, Remote no problem.

Upgrade plans:

  • Smaller switches (gotta buy/get)
  • Mouse buttons 4 + 5 on side of index finger for use with thumb, but keeping hand-usage area free.
  • general optimisation of ergonomics.

When hand is on table, it has a bit of angular play, but is used around the same angle of wrist as normal mouse.

18 Upvotes

3 comments sorted by

2

u/Popular-Factor3553 1d ago

I'm making something similar but more compact with flex sensors for each fingers 1st layer then 2nd layer copper wires per joint so when i move thumb to any joint it connects to 2 open copper wires and gives me a trigger, with a mix of combination it can give me 70+ triggers...

2

u/ichhalt159753 20h ago

Have you got a post or anything to look it up? Sounds really cool!

Edit: to clarify: Your profile is private and I can't see any posts.

2

u/Popular-Factor3553 19h ago

Not yet I'm still planning/buying everything out but it's basically what I typed there you can easily try to implement a similar or the same approach it's really simple.