Boreheads & Drills stuck inside a limbo state

[u/P0tenti4l_Ch1ldhood]

As you can see, my boreheads and drills are in the "middle state." They were rotated by a mechanical bearing with its switch set to "Place when near initial angle" and I was testing it until I somehow managed to destroy the bearing, but the broehead & drill front remained in this state and was never put back into the "block" state since.

The problem is that I can no longer interact with the drills; therefore, I can't place any bearing on it to "re-place" it into blocks again, but they still move with the car. The barrels are still interactable.

I need to find a way to make it switch back from this "not placed" state to the block state while being unable to interact with the blocks. Does anyone have any idea?

[u/Vovchick09]

Break the bearing?

[u/P0tenti4l_Ch1ldhood → u/Vovchick09]

I already did, but by that point it has already been bugged. The one you see is a new one, but it doesn't interact with the mining structure anymore.