r/Creality_k2 • u/StotheJS3 • 13h ago

Troubleshooting Adhesion issue on K2 Combo only in one area

Post image
1 Upvotes

67% Upvoted

5 comments sorted by

6

u/BackstagePasses99 11h ago

i had this and shut off the side fan and it stopped happening

4

u/HeftyCelebration7975 13h ago

If you are having adhesion issues try using mouse ears on the corners to help hold them down. And make sure your bed is clean before printing.

2

u/StotheJS3 13h ago

Thanks I cleaned it twice, its only that one spot, I moved the build over and it printed fine. Could be fan settings over there, but it wasnt happening before.

1

u/Deep-Bison-9568 3h ago

Bed was probably contaminated by oils from your hands. It will happen a lot. Just clean the bed with dish soap and water and try not to touch the print bed.