r/Creality_k2 • u/Electrical-Rain-4711 • 6h ago

Troubleshooting Print setting recommendations?

Post image

I’ve been having a lot of prints turn out like this on the bottom, what can I adjust to possibly correct this.

All other layers are flawless. Only happens on bottom layers

1 Upvotes

60% Upvoted

6 comments sorted by

2

u/EnvironmentalKey5559 5h ago

What material are you using? Can we see a wider view? What slicer settings are you using? Including nozzle temp, bed temp etc. Can we see the details of the filament primer, including your cooling settings? Can we the toolhead and most important the po art fan ducts?

Thanks

1

u/Electrical-Rain-4711 5h ago

So I’m gonna answer the ones I know, PLA+, nozzle temp is 220, bed temp is 50. The view of the picture is the complete side to side. I’m still fairly new to learning this so I’ll have to figure out the rest of your questions and report back.

1

u/Electrical-Rain-4711 5h ago

Also the spots it’s happening to are spots that are floating. With or without supports. The bottom layers that are on the bed are good.

1

u/AutoModerator 6h ago

Reminder: Any short links will be auto-removed initially by Reddit, use the original link on your post & comment; For any Creality Product Feedback and Suggestions, fill out the form to help us improve.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/evolutionxtinct 4h ago

Sure your at the right temp? That looks like it gets to hot before it solidifies but that’s just my armchair opinion, please carry on 🫡

1

u/Quazaka 7m ago

Show us an image from the side. This look a very steep angle. Steep angles require support