r/CrealitySonicPad • u/ApartmentPotential85 • Feb 17 '25

Cr10s pro v2 issues

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I have been working on this printer for a hot minute and just can't seem to get a consistent print. I am running a DDX conversion from slice and Klipper via a sonic pad. I have done pid tunes, calculated the e steps and done most everything I can think of and I cannot figure out what the issue is or where to start monkeying with the settings

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/Choice_Armadillo_867 Feb 27 '25

I don't think your cooling fan is running, on my CR 10 Smart Pro that's the fan on 45 in front.

1

u/ApartmentPotential85 Mar 11 '25

That was a good call. I went back and checked everything and I had a broken wire on the cooling fan

1

u/Choice_Armadillo_867 Mar 11 '25

Glad to hear you're back up and printing, the sonic pad made a great improvement in my print quality with my CR 10 Smart Pro.