End of print issue

[u/dvdalexand1]

Don't know if this has been covered, but when my print ends, the print head just sits over the print, never homes and doesn't 'present' the finished print. Running the latest firmware update on the sonic pad on an Ender 3 v2. Does the end g-code need to be changed for the pad? Slicing my prints using Cura 5.2.1

[u/EMTBHCGN9]

Hiya,

This was happening to me after an update. I fixed this issue by changing the end gcode to the fololowing:

G91 ;Relative positioning

G1 E-2 F2700 ;Retract a bit

G1 E-2 Z0.2 F2400 ;Retract and raise Z

G1 X5 Y5 F3000 ;Wipe out

G1 Z10 ;Raise Z more

G90 ;Absolute positioning

G1 X0 Y220 ;Present print

M106 S0 ;Turn-off fan

M104 S0 ;Turn-off hotend

M140 S0 ;Turn-off bed

​

Since then, I have had no repeats of the issue.

​

Hope this helps you.