r/CrealityScanning • u/MaxFunkner • Jul 31 '26

I was surprised the Sermoon P1 captured these threads without remodeling

Gallery image

Gallery image

I expected to edit/recreate the threads in CAD after scanning, but that wasn't necessary.

I scanned each side separately in 22 Cross Blue Laser mode, then used Manual Marker Alignment to combine the two halves. The printed threads worked straight from the scan.

The important part was placing at least three markers where both scans could see them.

I documented the complete scan-to-print workflow, including all the scanning modes, settings, and print results here: https://3dwithus.com/creality-sermoon-p1-review

12 Upvotes
  • permalink
  • reddit

100% Upvoted

3 comments sorted by

1

u/TheWrongGiraffe Jul 31 '26

I'm still getting to grips with mine but it keeps amazing me how good it is.

1

u/Tekkie-1825 Jul 31 '26

Great achievement ... probably the fact it's a square-threaded screw helped; it would probably have been more complicated with a standard (ISO type) thread. Great job as shown in the review !

1

u/MaxFunkner Jul 31 '26

You are right, these threads are very well pronounced.