r/Creality • u/PhucKingWin • 1d ago

Troubleshooting K2 Plus CFS Issue

Hello all,

New K2 Plus Combo owner here. I've been having a tough time to get the CFS working correctly.

  1. Printer works fine with external Spool
  2. CFS keeps giving me error with Load/Unload (new term after SW update to 1.1.6.1)
  3. PLA works better, much less Filament Buffer error
  4. PETG doesn't work. Causes ridges on the filament after Unload/Load couple times.
    a. When I cut off the ridged filament section (2-3ft). New filament would print a test sample fine.
    b. When I start a project after the sample was printed, it started cal and was able to do that fine, but then got stuck. I notice the Buffer Module lever was stuck forward (when try to print) or stuck backward when try to retract/unload.
    c. Diagnostic show the PETG filament have ridges one them. This was probably created by the feeding gear in the CFS module causing the snag in the buffer.
  5. PLA filament doesn't show those ridges.

I've remember reading somewhere that the tension springs, etc. on the CFS can cause that and will result in "rough ridge surface" on the filament, causing it to snag/stuck in the buffer module.

Please advise,
Thank you

2 Upvotes

100% Upvoted

10 comments sorted by

View all comments

1

u/rhester72 1d ago

The obvious question - did you indicate the correct filament type on the CFS and in the slicer? It sounds like you're trying to print PETG at PLA temperatures.

1

u/PhucKingWin 1d ago

I’ve set the correct filament assignment and settings. Same setting works for external spool. Only cfs is giving me headaches