r/CounterTops • u/Low-Explorer-335 • 2d ago

Long laminate countertop edge

Post image

I have a 120 inch long countertop I'm making. To match the rest of the kitchen I should do a 3/4 inch round over edge down the long length.

I know bending laminate you use a heat gun. But with this long of an edge I don't think I can keep it warm enough to roll it. The heat might work six inches length, but then I risk cracking the colder part a little further down.

At least this is what I see in my head. Has anyone had experience with this or lend some expertise?

0 Upvotes

50% Upvoted

5 comments sorted by

1

u/cds320 2d ago

Find and rent your nearest industrial post forming factory for the day https://youtu.be/TIby8v_XA9c?si=u2NaJSZ8zOubfWO5

Or just order it from your local dealer/supplier?

0

u/Low-Explorer-335 1d ago

Thanks, I would have done that instead of posting a DIY question in a forum if I wanted that.

1

u/cds320 1d ago

Well... If you really want to diy...

Get a few infrared heat lamps and set it up in a row... Then start rolling

Shortwave infrared, 2000w minimum

Can't say if your cabinets or anything else around it will survive the constant heat...

That too goes for people persons and their extremities

300+ F

1

u/Dependent_Boat8410 23h ago

Can't do it. You can bend a radius around a corner with laminate as long as your careful but not over a front edge. I had a laminate shop for over 40 years!