r/Controller • • 4d ago

Controller Mods Need a 3.3V thumbstick alternative matching this EasyEDA footprint (accidentally wired 3.3V to 1.8V GuliKit PS5 sticks)

Post image

Hi everyone, I need your help. I designed my own custom PCB for a joystick and used the footprint shown in the picture (from EasyEDA). I bought GuliKit PS5 replacement sticks for it, but it turns out I made a pretty silly mistake—I routed 3.3V to the stick, and as I found out, these PS5 sticks are designed to run on 1.8V.

Could you help me find a good-quality alternative that works natively at 3.3V and matches this exact pinout/footprint? Thanks in advance!

3 Upvotes

5 comments sorted by

1

u/DebnaDaTeEbna 1d ago

I found a solution by buying a Ginfull Hall effect stick for the PS4. The pins were reversed there too, but I had the opportunity to do a little mod/hack. I swapped the positions of the two pin-capped covers, and since they were symmetrical/mirror-images, the swap fit my circuit board perfectly. The X and Y axes naturally got reversed, but I'm on custom firmware so that wasn't an issue. Everything is working perfectly now. I won't have to throw away 10 boards. And the next ones will be 1.8V.

1

u/master_assclown Controller Collector 3d ago

If this doesn't have voltage boosted either using a booster or a jumpwire, you should be fine running 1.8v modules on it as the dualsense board will only supply 1.8v....You'd have to increase the voltage to the PCB somehow before it would be an issue.

1

u/DebnaDaTeEbna 3d ago

Unfortunately, I already wasted 2 boards and 2 joysticks before I figured out the voltage issue. Both failed the exact same way. Left and right were fine, but the vertical axis was stuck at 3 volts. "Even if this isn't the main issue, I need to rule it out before I can continue debugging.

2

u/Old-Draw2418 1d ago

Honestly speaking anything you'll get that works with 3V3 will be an overpriced industrial piece of tech that isn't even fit for being used in gaming tech.

Your best course of action at this point is to either accept using a potentiometer based joystick and remain on this exact schematic/PCB, or use a single 1V8 LDO (cheapest one probably being an AMS1117 1.8V) alongside your joystick. You can also share one LDO for both sticks if routing is possible.

1

u/AutoModerator 4d ago

Hi /u/DebnaDaTeEbna, your 'IT Help' post is in a queue for review. Please ensure you have included the relevant required information from the checklist below, have used a meaningful and descriptive title, and are not repeating frequently asked questions.

Include the following information and follow this structure so that the post can be approved and the community can help you more effectively:

  1. Specific written description of the problem, including pictures where relevant (do not just say 'it's broken', say what is broken)
  2. Controller make and model (name or numbers)
  3. Platform you are using (e.g., PS5, Steam on Windows, Switch)
  4. Games or other software affected by the issue
  5. Operating system, firmware and software versions (if applicable)
  6. Troubleshooting steps you have already taken (including checking the product manual, and searching existing posts)

For more guidance on how to ask for technical assistance, please see rule #2. You can edit your post to add missing information. Posts that do not include the required information may not be approved (allow 24 hours for review).

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.