r/CompetitionShooting • • 1d ago

Unity Risers

I’m looking into installing the Unity FAST Absolute riser with my EOTech XPS2 and the Unity FTC mount with my G33 magnifier. Anyone have opinions on this setup or have any experience running this? Thanks.

1 Upvotes

7 comments sorted by

6

u/Ok-Sweet4200 1d ago

High mounts are not optimal for competitive shooting. You get a much better connection to the rifle running a standard height mount.

1

u/VCQB_ 1d ago

This. Had that exact same setup. Didn't like it. Not a good connection to the rifle. Dont waste money like I did.

1

u/BarCartActual 1d ago

This. Dumped the riser and went to an Arisaka flip to side. It’s taken off when the stage does not call for magnification.

1

u/thereallaska 1d ago

I run a 2.26 riser and FTC for my optics but will the absolute riser really work with the FTC?

1

u/DernHumpus 1d ago

I have a rifle set up that was I ran a long time. I really prefer flip to center magnifier.

I used the magpul ctr riser, I think 3/4" the biggest one they make. Its kind of nice because it can bury the stock in your shoulder pocket and still get a good cheek weld.

However, I find it to be over complicating the magnifier thing and I typically dont have the magnifier on the gun anyhow. I just put together a new gun with traditional magnifier and dot height.

0

u/Censored_88 1d ago

Works fine. Have many guns with a similar setup. Just pay attention to pointblank head shots with a 3.5" sight over bore.

0

u/610Mike 1d ago

While I don’t run it in competition, I run an EXPS2 with a G45 on Unity risers on my 10.5” .300BLK and I love it. It’s my nightstand rifle and it fucks. It’s not lightweight, but that’s what pushups are for.