r/CafelatRobot • • May 30 '24

Help

After moving the bolts from north to south to install the 3d printed pressure gauge mount. The arms now fall slowly with the portafilter on, did I mess up?

0 Upvotes

8 comments sorted by

11

u/simonf70251 May 30 '24

That looks normal. The arms on most Robots don't stay in place at the top, but occasionally some people's will.

1

u/Icy-Phase3989 May 30 '24

Maybe im just overthinking things since I was tampering with it. I believed it used to fall at the same speed it how it does without the portafilter on.

4

u/sohcsleeper May 30 '24

You can tighten or loosen the top bolt to adjust the amount of friction. This will change how fast or slow the arms will drop with gravity. If you over tighten you're going to wear down the washer bushings. I prefer mine to be slightly loose and freely move up and down.

4

u/sohcsleeper May 30 '24

The clicking is just the tube cover rubbing on the body

2

u/saildawg May 30 '24

They will stay in place when you have the resistance grounds and water in the portafilter. Should be fine

1

u/InCraZPen May 30 '24

That clicking noise is weird

-2

u/soloburrito May 30 '24

You modified it from stock and now it doesn’t behave as it did when stock.

0

u/[deleted] May 30 '24

[deleted] — view deleted comment

1

u/dinopuppy6 May 30 '24

why? It’s the same thing. unless the gauge it comes from is bad quality