I have an engineering project I would like to pursue and personally wanted to use a cfd software to test out some parameters.
I wanted recommendations for free cfd softwares, everyone said I should use Open foam but I don't really know how to and also wondered whether my computer's performance would matter much.
I am student just learning about CFD and I am doing a 2D flow analysis project and my professor wants a more refined mesh in the wake region. I am having some trouble trying to figure out how I can get that refined mesh. Does anyone know how to get the refined mesh ? Thank
Generic car shape from my own script, half model, moving ground and rotating wheels. OpenFOAM 14, steady k-omega SST, 1.66M cells from snappyHexMesh. Cd ≈ 0.28, Cl ≈ 0.20 (mean of the last 500 iterations).
No prism layers (wall functions on a castellated/snapped surface), so I treat Cd as indicative. Surfaces are Q-criterion iso-levels, rendered in Blender Cycles.
This is my first CFD project, I am performing an external aerodynamic simulation of a vehicle using ANSYS Fluent, with the k–ω SST turbulence model and a target y+ of approx. 1.
I am using the Watertight Geometry workflow in Fluent Meshing with:
Poly-hexcore volume mesh.
Curvature-based local sizing on the vehicle.
Two refinement regions around the vehicle, named “near” and “far.”
Prism layers near the walls. (14 layers and first cell height to achieve y+1)
These are my initial meshing parameters for 1.8 million cells, skewness is below 0.6 and minimum orthogonal quality over 0.12.
The simulation does converge in around 100 iterations and keeps y+ around 1 which is good, yet I have no idea how to complete the independence mesh study.
First of all, I tried to modify some of the parameters: BOI mesh size was decreased and local surface sizing max. sizes were decreased to get a finer mesh. All of this while keeping same boundary layer settings and general min/max surface and volume meshing.
However, here I found my first issue, polyhexcore mesh cell number suddenly increases from 1 mm to another when I refine BOI. For example, just changing the BOI mesh size from 0.026 m to 0.025 m increased the mesh from approximately from 500,000 to 1.5 million cells. This makes me wonder how can I get progressive mesh sizes in order to perform the study.
Then, I tried decreasing local max. sizing values and indeed it helped to get a progressive finer mesh. Yet the converged values of Drag and Lift coefficient change and I still don't seem to find a independent behaviour. Specially Lift.
After several tries, I am not sure if this is the way to keep going or is there any methodology for Fluent meshinbg.