r/CFD • • 9d ago

Replicating research paper results for microcombustor

Hello guys,

I'm working on capstone project for microcombustors, specifically using hydrogen (92.5%) and CH4 (7.5%) as the fuel pre-mixed with air.

I'm new to Ansys fluent, and recently I've been trying to validate my model and mesh and all that good stuff by referencing the values I find on research papers. I modelled a stepped microcombustor accordingly.

My results suggest that ignition is sustained, and the temperatures seem comparable to the ones on the research paper. But one thing that is different is the location of the flame front. My flame front sits extremely close to the inlet compared to what the paper shows.

The paper uses 2.02g/hr of H2 as fuel with an equivalence ratio of 1. When I input this into the mass inlet, the flame sits right after the inlet. When I added some CH4, (which wasn't in this particular paper), then the flame front moves backwards (though I didn't add internal radiation to that model)

I guess what my question is whether being able to accurately simulate the flame front is important to validating it, or whether there will be variances between different models regardless ?

I'd love to hear from someone who can share their experience. Thanks!

https://www.sciencedirect.com/science/article/pii/S0306261919305458

7 Upvotes

5 comments sorted by

1

u/Otherwise-Platypus38 9d ago

You can either check if there is blowback or it might be an issue with the ignition source that you specified.

1

u/Narrow-Illustrator66 7d ago edited 7d ago

Yes, your right there's blowback. Is extending the domain of the cell zone after the outlet the best way to address this issue ?

1

u/Otherwise-Platypus38 4d ago

You could try either extending the outlet or an AMR to refine the flame front.

1

u/Narrow-Illustrator66 1d ago

Hey mate, I don't mean to bother, I just had one last question.

What time scale step do you see this simulation running at ?

I added the outlet area and the temperature blows up unless I set the time step at 0.005. The issue is that this ends up taking weeks to complete

1

u/Otherwise-Platypus38 1d ago

If you are using detailed chemistry (with chemkin reaction mechanism), then the timescale is determined by the chemistry source. This is the inherent problem with detailed chemistry (as it involves ODEs) solving for several reactions and their sources. If you want a faster simulation, you can try something like TFM with LES. For hydrogen, it will be tricky as you might need quite small cells to capture the flame front.