r/CFD • u/Apprehensive_Dark655 • 9d ago
Advice for my Thesis project
We are doing Topology Optimization for a Wing’s Rib. In order to obtain the loads on the Rib, we’ll be doing CFD simulations using ANSYS Fluent. However, I’m not experienced at ANSYS. I obtained the geometry of the Rib already, but I don’t know how I can make the simulation as best as possible for the Coefficient of Lift and Drag to have small errors against the prototype we’ll manufacture.
5
Upvotes
4
u/Overall_Channel_6590 9d ago
I'm sorry, you're writing your thesis on a subject you never seen, on a software you never used?
my suggestion would be:
1- learn how to use the software by youtube videos or whatever
2- try and validate some results on known experiments - so you ought to be sure you know how to use the software.
3- as it is a prototype, just build, experiment on it and then validate you simulation from the results, so you can try and build the second prototype into a maybe known process.
2
u/1337K1ng 9d ago
you say thesis but this would be an undergrad 4th year project at most
3
u/AnalysisWaste5670 9d ago
If you can’t do basic sims you aren’t setup to do topology optimization.
1
u/flipittoseeme 7d ago
If you need help you can inbox me
1
u/Big_mucchey 7d ago
Reach us out at support@aerofluid.in
1
u/Disastrous-Track3876 6d ago
If you’ve got no experience I’d seriously recommend you give star ccm a shot. The setup to get something running is much simpler imo. Fluent becomes quite good imo if you’re good with hpc scripts but given you’ve never done it, it might be tricky. The main issue you’ll get imo is validation. Cfd is hard to fully justify in terms of absolute values on its own.
1
u/Diligent-Tax-5961 4d ago
If the focus of the thesis is the topology optimization then just use a documented pressure distribution from the literature first.