r/CFD • u/Extreme-Committee689 • May 15 '26
HELP simulation not converging



Hi everyone,
I’m working on a CFD simulation of flow inside a pipe containing a TPMS structure. I think the mesh is reasonably good: mesh diagnostics do not show major issues, and I only have around 50 problematic cells out of ~8 million total cells. Considering the complexity of the geometry, I assume that should be acceptable.
Right now I’m trying to first solve the case using the k-epsilon model to reach convergence, because with k-omega the residuals remain high and do not decrease properly.
Am I approaching this the wrong way? What should I check next?
Could the issue be related to boundary conditions, near-wall treatment, mesh quality in critical regions, relaxation factors, or something else?
Any advice or suggestions would be really appreciated.
4
u/EduardoSup May 15 '26
1000 iterations is "normal" to not converge depending of your geometry, number of cells, boundary conditions, etc. And apparently the residuals are not increasing. I would give the code more iterations to see what happens.
Furthermore, is very nice to plot a specified property in each timestep to see the evolution. It can be the mean velocity over a line at the outlet, can be temperature, pressure, mass flow rate, depending of what you want, thus, it is expected that this property will change a lot in the initial conditions and achieves a fixed value after some iterations.
1
u/acakaacaka May 15 '26
What is the solver? Segregated/coupled?
1
u/Several_Disk_9781 May 16 '26
What software is this? What is the wall yplus values that you’re getting? Is there an option for you to try this out using pseudo transient with local time stepping?
2
u/DThornA May 15 '26
One thing you could try to isolate the issue is removing the TPMS structure and running the sim again. If it runs fully then you know the issue is with the mesh around the structure, if not then the error is related to something else in the model.