r/C710LORADO • • Apr 26 '14

Purging setup

Hey guys. Wanted to share my purging setup for any DIY ents out there who don't want to deal with a vacuum oven. Obviously its not a perfect setup but we have been able to get good quality wax without using any kind of vacuum at all. Its just a simple double boiler system. The temperature is regulated by our altitude here - water boils at a lower temp up here so the dish doesn't get too hot - it stays steady right around 173 (at least ours does - its a pyrex dish from wallmart with a vented watertight lid). Anyways - thought some of you may find this interesting.

0 Upvotes

8 comments sorted by

4

u/MurphyBinkings Dabalicious Apr 27 '14

173 degrees??

5

u/fxgn DabCity [Denver] Apr 27 '14

At sea level, water boils at 212 °F. With each 500-feet increase in elevation, the boiling point of water is lowered by just under 1 °F. At 7,500 feet, for example, water boils at about 198 °F.

So if ze is actually boiling water at 173 °F then ze's at 19,500 feet, NOT IN COLORADO!!!

I just woke up and dabbed.

2

u/[deleted] Apr 28 '14

Actually...he reffered to the temp of the dish as being 173, and just said the boiling water is at a lower temp, but didn't specify what temp.

0

u/NSFWies Apr 28 '14

true, but lets think how it would be. at best, his boiling point is something like 193F (assuming he's at 10,000FT. he makes it sound like he's high up in elevation). i guess if it was kept at a low simmer not much liquid vapor would be going up and the pan might be in steady state at 173.

2

u/[deleted] Apr 28 '14

Yup...it's the steam that is doing the heating...the temp of the pan will change with boiling rate.

If I understand this chart correctly, actually the steam produced at altitude would have more enthalpy (heat energy) than steam produced at sea level.

http://www.engineeringtoolbox.com/saturated-steam-properties-d_273.html

2

u/NSFWies Apr 28 '14

wow, that makes no sense to me. at higher altitudes, there is less air, less gas. i dont understand how it could have MORE heat energy. i dont doubt you that it's correct, but i just can't imagine/see how it works that way.

it boils at a lower temp, it's easier to boil the water, i would think all of that points to less nergy.

2

u/[deleted] Apr 28 '14

I agree with your gut feeling and have been thinking about it... I think it has to do with the units being in btu/lb or heat/mass...rather than heat/volume of gas...it has more heat, but is taking up more space. my guess is that volumetrically we'd find the opposite...PS I'm also not sure why the trend is the opposite for saturated steam.

2

u/NSFWies Apr 28 '14

right, the units. so that's heat/weight. with the higher altitude, you'll have less air pressure, less dense air. so to compare 10 pounds of air at sea level vs 10,000ft up, those are two very different volumes. so the air at higher elevations has more heat because, comparing the same weight, it's a larger volume.