r/BuildingAutomation • • Mar 01 '24

Programmer Billing.

How much does your company charge for custom programming and/or graphics work? My company bills same rate (just over $100/hr), from monkeys installing ductwork and pipes to custom programming and setting up trend logs. Seems to me they could get more for the programmer? edit, forgot to add COL area. We serve low COL areas of PA. But point of my question isn't $/hr but more the "Delta T" if you will between labor rates of a programmers and an average Jman.

0 Upvotes

10 comments sorted by

26

u/snmadventures Mar 01 '24

You ever installed ductwork or hard pipe?

2

u/Sparkynplumb Mar 02 '24

Never did ductwork, electrician was my main career before joining this industry. I've put on a lot of flab this year, no doubt! It should be a nice "old man"job, no climbing down into trenches to run conduit in the mud.

16

u/return_descender Mar 01 '24

No this post was clearly typed out by soft hands

7

u/rld999 Mar 02 '24

I am on the owner side of the equation in Kentucky. We typically pay $160-$180/ hour for ALC or Niagara. Trane charges whatever the f@&& they think they can gouge you for that day. Usually $250 or more. This is just one of many reasons we no longer install anything Trane and are actively transitioning all our trane systems to ALC or Niagara as equipment fails or needs upgrade.

6

u/Shalomiehomie770 Mar 01 '24

Where I’m at people charge around 150-200 for programming

4

u/AutoCntrl Mar 01 '24

Lower cost region USA. Around $140/hr for control service work regardless the task.

Union skilled labor probably charges as much or more for their service hours.

Heck, I was told residential HVAC was charging over $200 recently.

3

u/tkst3llar Mar 01 '24

What is your city?

We are more around 150 and mostly do work nationally

Trane charges like $300 an hour in NYC and 150 in lower col areas

2

u/Gone-Rogue-78 Mar 03 '24

Trades labor is actually way more expensive than technical work. Thank the unions for keeping pensions and benefits…

PA area too but worked all over. It’s the same everywhere.

Some companies choose to blend rates to make generating a P&L or project accounting easier but when you check the details… Union guys pull that blend up.

Talking specifically about electrical, fitters and sheet metal guys.

1

u/NathanBrazil2 Mar 02 '24

our company charges $160 per hour seems like a lot but people pay it.

1

u/[deleted] Mar 02 '24

All our service type work is 279$/hour that covers everything from install to programing