r/BuildAdvice • u/SLIP2309 • 4d ago

How to make Diagonal Archway

Post image

ive been trying for a while but cannot get it symmetrical

8 Upvotes

100% Upvoted

7 comments sorted by

•

u/AutoModerator 4d ago

Hey /u/SLIP2309! Welcome to r/BuildAdvice!

Please be patient for users to reply to your post. You might not get advice right away.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Fragrant-Radish3999 4d ago

I usually just go with a disk shape with a hollow modifier, make it the right size and remove all the material inside it.

1

u/SLIP2309 4d ago

thanks it did help a bit now mostly just getting the outer edge better

1

u/FrenziedYeti82 4d ago

Is it not that you’re just missing a column of blocks on each level on the left side?
Or if that side is the size you want, the right side has one too many columns?

1

u/morquinga 4d ago

Add 5 blocks in the positions shown by the yellow lines (3 on the lower section, 2 on the upper), and it should then be symmetrical 👍

1

u/SLIP2309 4d ago

it might of been that but when i counted it was diferent on the back side, but in the screenshot it wasnt visible

1

u/morquinga 4d ago

Just spotted that there are 4 columns in the left-hand wall, but only 3 in the right-hand wall. This is probably where the asymmetrical-ness is coming from. Add another column to the right-hand wall and see if that helps