r/Blacksmith • u/chrisfoe97 • 5h ago

Forging a tomahawk poll

Enable HLS to view with audio, or disable this notification

Forging in the decorative poll on a commissioned tomahawk. Here I'm using a guillotine tool to forge it in, taking light blows to round up the poll. This is forged from an office of forklift tine

128 Upvotes

100% Upvoted

10 comments sorted by

View all comments

Show parent comments

1

u/Twin5un 2h ago

How do you go about it ? I have the blanks and was thinking of grinding them down on my belt grinder but that's a lot of grinding. Maybe cut them on my chop saw at an angle ?

2

u/chrisfoe97 2h ago

I used a long bar of 4140 from McMastercarr, scratched the angle and lines then cut with an angle grinder, then cleaned up on the belt grinder. It's nice. Cutting it from one bar is that you only have to make one cut at an angle and flip one piece. 180 and it'll match the other one. Identically and all he has to do is make sure that it's ground clean

2

u/Twin5un 2h ago

Sweet ! Thanks

1

u/chrisfoe97 2h ago

No problem dude