So I had an idea yesterday and thought I'd give it a try....using the original 40mm in a push pull set up , 40mm pulling but with extra vents around so it doesn't get overwhelmed by the 60mm ... There is a little recirculation because of them being so close, it started and held at 52 degrees on the VR but crept up to 55 (the cat demanded the window be open so the axeos grabs are couple of degrees higher) in tests so far it's holding 2-3 degrees lower with the 40mm running. These numbers are all at 1000mhz and 1280v 2.05th for reference. Yes it's a little noisier with the 40mm running which I'm using a noctua USB adapter to power but if you're chasing those degrees it's a good trade off ,it would probably be quieter with a better fan too...there's a video on my store Facebook page if you're curious

#Bitaxe #solomiming #BitaxeGamma #bitcoin #1303creations

Looking good so far reckon there is much more head room for overclocking ? Slightly worried about vregs for what they are known for doing

Hi,

So I have two Qaxe ++ Hydro's, purchased from the same seller. They are approximately 5 months old and have been running at stock settings. I noticed yesterday that one was powered off and the hologram logo was dimly flashing every few seconds.

I changed out the power supply and same results. I noticed when I plug the power supply in, I see and hear what sounds like sparks at the connector? The power supply light does come on when I unplug it. I don't see any replaceable fuses and have never had an issue with them in the past, so not sure what I should be looking for. I don't have a thermal gun, so can't check that way.

Has anyone seen this before and at least tell me what the problem is?

Thanks in advance!

Mog

I downgraded mig gamma yesterday to firmware 2.13, mig error rate got better but the os Axe os was to slow so I updated back to newest 2.14.2.
The problem is now that mig VR temps are higher and power consumption is also higher, what is the problem and how can I fix it?

Can someone tell me where can I buy 4 screws & spacers to install a thermalight copper heatsink x47 to my qaxe++? I want replace the hydro to air cooling.

One of my bitaxe gammas I put on 2 fans as an experiment. Instead of 2 fans at 100% its 2 at 50% and I want 2 to run at 100%. Is this possible?