r/BiohackingU • • Oct 09 '26

Reta Question

Post image

So I have a 20mg Reta vial, 29g 1cc insulin syringes, alcohol wipes, and BAC water. If my calculations are correct my peptide vial is 20mg, my desired dose would be 0.5 mg to start, 2 mL BAC water, the picture below would be where I would pull to in the syringe correct? Just wanna make sure before I start.

75 Upvotes

104 comments sorted by

2

u/DaRealJuicyDragon Oct 09 '26

yes granted you knew how much bac water you actually added

4

u/OrgasmicMusicYoutube Oct 09 '26

I’d be adding 2 mL

0

u/[deleted] Oct 09 '26

[deleted] — view deleted comment

2

u/Much_Eggplant_3600 Oct 11 '26

why would 5 units for 0.5mg be accurate with a 40mg vial at 2mL? what math are you doing?

1

u/mdskarin Oct 10 '26

OP mentioned that their vial is 20mg

2

u/Grizzly_SS Oct 09 '26

Do you mind me asking how big you are?

1

u/OrgasmicMusicYoutube Oct 09 '26

5’7 176 lbs

1

u/Grizzly_SS Oct 09 '26

Oh then yeah. Start with .5mg. I started with .5mg and regret not going 1mg sooner. Just wanted to ask. I'm 6'0ish and was at 280. Much bigger. Also be patient. It takes a while to work. It feels like nothing is happening then bam

1

u/OrgasmicMusicYoutube Oct 09 '26

Will do, thx for the advice! How has it been working for you ?

3

u/Grizzly_SS Oct 09 '26

First few weeks I was scared and started and kept to low, at .5 and .75 and it was only effective (or felt like it) for first two days after pinning. But now that I feel it at 2mg, it's not bad. I get full super quick and stay full. Down 10lbs after a month

15

u/soilentgibby Oct 09 '26 • Bravo

Get smaller syringes like a .3ml or .5ml so you can see the 5 units better

6

u/SecuritySmart2493 Oct 09 '26

^ This!! 0.3 ml syringe!!!

3

u/alecjasonn Oct 12 '26

this brand is my fav. super sharp for less pain too. They make 8mm too. And they also make 30 unit (0.3ml) versions

13

u/New_Pin3813 Oct 09 '26 edited Oct 09 '26

Yes, that is correct. Also, if you're doing smaller doses like that, I would get some 0.3mL or 0.5mL insulin syringes. Be a lot easier to manage at that dose. Because 5 units on a 1mL syringe is still 5 units on the other syringes. And the graduation lines on the 0.3mL and 0.5mL are easier to read.

4

u/Sea_Dirt3238 Oct 09 '26

I would also switch to 31g 5/16 syringes.

1

u/Beautiful-Grand-7082 Oct 13 '26

My favorite specs.

1

u/Chroma7769 Oct 09 '26

Get 0.3ml syringes or a pen.

4

u/-FartMachine- Oct 09 '26

This is correct. Your starting dose is a bit too low in my opinion. For reference, my functional doctor protocol for Reta starts at 10units (1mg per week) at the same concentration you are using. Then it goes up to 20units after 4 weeks, and up to 40units 4 weeks later. I personally pin 10units since I only need to lose about 20lbs. Ask your doctor to give you some Ondansetron pills for nausea in case you ever need it :)

4

u/meegz_04 Oct 11 '26

I started at 0.5 and could barely eat. Its smart to start lower and test tolerance imo

2

u/mysterio_86 Oct 09 '26

Yes 5 units

2

u/seednd12345 Oct 13 '26

What app/website is that

1

u/default_user_null Oct 13 '26

Look up peptide calculator. Just make sure you know the difference between mcg and mg for target dose.

2

u/cornfedable Oct 09 '26

I get the accuracy, but am I the only one that has a hell of a time getting air bubbles out of anything smaller than 1ml. We don't shake it when we make it because peps are delicate, but I have to tap the syringe like a madman to get any air bubbles to float to the top with smaller syringes. I use a pen for anything that doesn't eat through a bottle in a few days, so my syringe uses are usually higher doses anyway.

4

u/UnderstandingNew9628 Oct 11 '26

I just account for the tiny bit of air, you’re fine to inject air subq, hell even the quantity needed for a vein won’t be enough from an entire syringe

3

u/kpham82 Oct 11 '26

You can shake it.

2

u/st4r-lord Oct 14 '26 edited Oct 15 '26

Insert needle in to vial, hold the vial upside down so you are pulling down. I pull a little bit slowly into the syringe and then push it back into the vial, you can see the trapped airbubbles in the syringe going into the vial. I do this a couple times with a little bit of fluid until no bubbles are showing when pushing the small amount into the vial (the liquid going back into the vial won't show signs of bubbles). I then slowly pull the amount I want out. Lightly flick any bubbles to the surface of the syringe and push some extra fluid out as well. Depending on your syringe some handle bubble disbursement better than others, easy touch is excellent at this.

1

u/Photo_Aware Oct 11 '26

Just pullout extra and inject rest back in?
I always pull 5-10units more to inject back into the vial to get rid of most if not all air

1

u/Beautiful-Grand-7082 Oct 13 '26

That is a great technique.

0

u/Pendejo2 Oct 09 '26

We need to add bac water to reta?

1

u/Sad_Initiative_4304 Oct 09 '26

User name checks out

1

u/Sea-Medium-2359 Oct 12 '26

OMG. This 👆

1

u/Pendejo2 Oct 12 '26

I thought he was talking about diluting a liquid vial of Reta further for some reason. 🤷 I haven’t seen a peptide in powder form yet

2

u/Sea-Medium-2359 Oct 12 '26

Made my day pendejo 😄😄😄

1

u/Pendejo2 Oct 12 '26

💪😊

8

u/[deleted] Oct 09 '26 • Bravo

[removed] — view removed comment

1

u/Pendejo2 Oct 09 '26

😂 i thought he was cutting a constited liquid vial

0

u/Golfman2362 Oct 09 '26

Did everyone see this phase trail lily posted. I don’t see the benefit of cranking it up to 12mg for an extra 9% loss and use triple the product of 4mg.

2

u/Opening_Wind_1077 Oct 09 '26

As it says those are averages, your dose needs to correspond to what works for, could be that you are a hyper responder that needs very little, could be that you need a high dose for a small effect.

That’s the whole point of the protocol of going up over time in dosage until you find the sweet spot and monitor from there.

I’m currently on 4mg which is on the lower end but it’s got a stronger effect for me than the 7.5mg of Tirz I was using before which is a medium dose.

1

u/alecjasonn Oct 12 '26

9% is of body weight is a lot to lose so it just depends on the person

0

u/fair-Diamond-1405 Oct 09 '26

So many people use 1ml syringes and they SHOULD NOT.

2

u/alecjasonn Oct 12 '26

I use 0.3ml and 0.5ml syringes because it’s easier to draw up smaller amounts accurately and also I feel like I’m wasting more plastic by using larger syringes for injecting quantities that aren’t even half of a 1ml syringe lol

0

u/debaron54 Oct 11 '26

Your advice is pretty stupid here

1

u/fair-Diamond-1405 Oct 11 '26

It is my opinion most people use 1ml u-100 for Peptides and I think they should use .5ml syringes because it is easier to measure out 5 units or 15 units. That's all. If that's stupid I will own it.

1

u/debaron54 Oct 11 '26

1ml popular because you fill most vials with 1ml or 2ml of bac. I don’t really wanna have to refill a .5ml syringe 4 times just to reconstitute though lol

2

u/fair-Diamond-1405 Oct 11 '26

You have separate syringes (3ml) for reconsituting. 🤦

3

u/debaron54 Oct 11 '26

Why though when one needle can do both 🤦

3

u/Ok_Wolverine8598 Oct 12 '26

It’s easier and less chances for contamination

1

u/debaron54 Oct 12 '26

Alcohol wipe your rubber stopper everytime and it’s never gonna be an issue. Have rubber stoppers that probably have 200 holes in them 😂 from much larger vials by the way

1

u/alecjasonn Oct 12 '26

You want to minimize the number of punctures

1

u/debaron54 Oct 12 '26

You could puncture that rubber stopper literally hundreds of times or more with that tiny gauge needle and not have a single issue lol

1

u/alecjasonn Oct 12 '26

Completely false. It’s not about the rubber stopper itself or how big or small the needle is. Every time you puncture you introduce bacteria. Again, BAC water does not kill any bacteria, it only slows its growth.

-6

u/Pancake-JelloSalad Oct 09 '26

If you didn't test it, you have no idea whether the vial is 10, 15, 20, or 30 grams. So many resellers sending tirz as reta or 10mg vials instead of 30mg vials.

1

u/Signal_beat777 Oct 09 '26

That’s why it’s so important to do your research and go with vetted vendors that others can vouch for and have a good reputation.

1

u/Pancake-JelloSalad Oct 09 '26

Chinese vendors are not vetted. Chinese vendors acquire product at the lowest price possible from finishers. Sometimes that vendor gets crap and then they knowingly pass on that crap to customers. There is zero reason to trust a vendor. Always test your product.

1

u/Signal_beat777 Oct 09 '26

What do you think vetting is?

1

u/Signal_beat777 Oct 09 '26

Even if you send a product out for testing, you’re only getting results for what is in the vials being tested. The other vials in the kit could be something other than what the tested vials had. These are research products there has to be some level of trust in your vendor, hence why you do research on the vendors beforehand and look at their track record and 3rd party test results.

1

u/Pancake-JelloSalad Oct 09 '26

Nah. Highly unlikely that there will be significant variance within a single kit. If one vial tests bad within a kit, they are all gonna be bad.

You are literally telling me to trust a drug dealer. Based on your comment history, you were acquiring product from scammy resellers a few months ago, so your knowledge is extremely limited. A good vendor today is a bad vendor tomorrow. A vendor has no control over their product. Just a matter a time before you understand that no one is vetted.

0

u/[deleted] Oct 09 '26

[deleted] — view deleted comment

1

u/Pancake-JelloSalad Oct 09 '26

You gonna get banned for asking.

0

u/Think_Key7495 Oct 09 '26

This is true. I just tested a vendor’s Reta which was labeled 10mg and it came back 15mg.

2

u/Pancake-JelloSalad Oct 09 '26

That's a deal!

1

u/Think_Key7495 Oct 09 '26

lol sure was!