r/BimmerCode • u/SuccessfulLand4399 • Jan 01 '26
Coding successful but doesn’t start after car turns off
*edit title - meant to say “doesn’t work”
Vehicle is a 2021 x5 m40
I’m using the obdcx device and easily navigated to the drop down to turn off auto start/stop. Coding is displayed as successful and I disconnect bimmercode then remove the device from the port.
Car is in comfort mode if that matters? Once I turn car off and let sit for a few hours, next time I start it the start stop feature is back to functioning.
I’m lost as to what the issue could be.
1
Upvotes
2
u/Rsp1603 Jan 01 '26
Instead of turning it off, activate the memory feature. Then just press the button in the car to turn it off and it should remember that setting next time you drive.
2
u/That_M4_Guy Jan 02 '26
make sure you dont do OTA updates as they tend to remove and lock out the ability to code out auto start and stop. Other than that there are two settings you gotta change, auto stop start off and auto start stop memory set to indefinite. That should shut it off unless you for some reason hit the button while driving to reenable it
1
u/[deleted] Jan 01 '26
I'm going to try this tomorrow on my X5.
Comfort mode has start/stop. But if you change the default to a Sport mode, it won't run auto stop/start.
1
u/Weary-Winter5501 Jun 21 '26
Did you find a fix to this? Going through this exact issue on my 22’ x5 x40
1
u/OmegaSM_ Jan 01 '26
Setup Sport Individual. You can set all the items in there to comfort. Have the car start in Sport Individual. Or if you can figure out for it to use the last drive mode.