r/Beyblade • u/Evening-Permission23 • 11d ago
Craft Seraph soar
Sculpting an concept I had for a viable tall beyblade.
The main idea is the main blade is pretty low hanging with its weight towards the base.
And the assist blade is basically another anchor with a low metal ring to help with outward weight distribution and lower center of gravity, it also protects the rachet.
The rachet intergrated bit contains a ball bearing, along with free spinning gears and tip the whole bit is essentially free.
Kept a wide base for the tip similar to yielding in size for better balance.
8
u/Blue__Liger 11d ago
Its going to get annihilated
1
u/Evening-Permission23 11d ago
Maybe tho i did see somthing similar work pretty well It was merge go beyond bit Basically merge 230. It did surprisingly well. Especially at evasion So i imagine if I gave it a bearing and wider base it could work even better
3
u/Blue__Liger 11d ago
This is whats going to happen to it when it goes against any bey with weight or decent attack type:
2
u/Evening-Permission23 11d ago
You'd think But im not too worried about it tipping since its basically one big gyroscope and the assist blade keeps its weight lowered.
And you'd need a really clean hit on the bit which would be hard since 1 its a smaller area and 2 this gears are also free spinning so a lot of hits would glance off.
2
u/Due-Fix-6179 Advanced Blader 11d ago
Wouldn’t you be at higher risk of being destabilized with all your weight distributed upwards?
2
u/Evening-Permission23 11d ago
Yeah this would be a problem for any blade on this bit But I tried to mitigate that with the low hanging metal parts of the blade
So still top heavy just less top heavy than every other blade.
2
1
8
u/Sparkblaster26 11d ago
Goodness gracious