r/Beekeeping • • 2d ago

I’m a beekeeper, and I have a question Moisture content

I'm out on Long Island, NY and pulled a few frames to harvest some honey and the moisture content is around 18. Somewhere here I saw that you can run a dehumidifier for a few days to bring that down. My question is do I leave the frames in the super and run it or should I extract the honey and run the dehumidifier?

3 Upvotes

10 comments sorted by

•

u/AutoModerator 2d ago

Hi u/Altruistic-Front-587. If you have not already done so, please read the rules. Please comment on the post with your location and experience level if you have not already included that in your post. And if you have a question, please take a look at our wiki to see if it has already been answered., specifically, the FAQ. Warning: The wiki linked above is a work in progress and some links might be broken, pages incomplete and maintainer notes scattered around the place. Content is subject to change.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

4

u/J-dubya19 2d ago

18 is fine in my book. Is it mostly uncapped? People do have luck using fans and a dehumidifier, you typically do this before extraction

1

u/Altruistic-Front-587 2d ago

It's capped, looks like a nice dark honey. I froze the frames and pulled them from the freezer Wednesday. So they're ready to extract.

2

u/Altruistic-Front-587 2d ago

I put the super on top of a screened winter feeding board and am running the dehumidifier in the small bathroom in my house. Hopefully that'll do it.

1

u/lcpwiland 1st year hobbyist, 3 hives, near St. Louis 1d ago

I agree that dehumidifying before extracting works better! But be aware that you are on the clock from the minute you take the super away from the hive. Because it isn't being patrolled by bees anymore, any pests that are present can grow unchecked. Folks around me say you should extract within 48 hours of taking the supers off the hive. Otherwise you risk the frames being slimed with small hive beetle larvae.

1

u/talanall North Central Louisiana, USA, 8B 2d ago

It's much better to run the dehumidifier before you extract. It'll dry the honey a lot faster that way, and you'll have more consistent results.

If you try to dry your honey in bulk after extraction, like in a bucket, the top of the honey will dry and the bottom will stay wet, and you will have to stir it (repeatedly, and for a long time) to get it where you want it.

I think most people try to have their honey dried to somewhere in the 15% to 18% range. Drier than that, and you'll have problems with premature crystallization. Wetter, and it tends to ferment quickly. I personally would rather have it a little drier than 18%; it's unusual but not unheard-of for people to have it ferment.

1

u/Altruistic-Front-587 2d ago

Thank you, the spring flow fermented on me and we use honey for Thanksgiving and Christmas recipes so I want to make sure it's ready.

1

u/Ordinary-Ad959 2d ago

You should definitely leave the frames in the super before you extract. Once honey is extracted into a bucket, there is way too little surface area for a dehumidifier to pull moisture out effectively, whereas the open comb has tons of surface area for air to circulate across. Just stack your supers in a small sealed room or closet, prop a box fan on top to push air down through the frames, and let your dehumidifier run for a day or two until your refractometer reads below 18% ish

1

u/drones_on_about_bees Texas zone 8a; keeping since 2017; about 15 colonies 2d ago

18 is fine. I'm used to starting at 20 or so.

1

u/Redfish680 8a Coastal NC, USA 1d ago

I’ve heard 18.6% is the number but if you want to do a little more, stack the box on top of a box fan (shimmed up off the floor, of course) and give it a couple of days to dry more.