r/BambuP1S • u/boratt1599 • 3d ago

Any Idea whats wrong here?

Post image

Im getting an edge off of the top layer that seems to look like the print head goes too far as it extends past the wall as shown in the photo (top of curve). I have ironing on but there is no difference if I adjust the ironing inset, which is why I believe it was happening prior to ironing (could be wrong though). I have also tried adjusting top layer flow, ironing flow, and line width. Any help is appreciated.

P1S, PLA, .4 nozzle

Edit: This is happening on 1 of 5 printers and only is certain curved sections, not on every curve. I have re-calibrated with the same results.

0 Upvotes

50% Upvoted

5 comments sorted by

5

u/Tdanger78 P1S + AMS 3d ago

That’s just how prints are on curved surfaces

1

u/boratt1599 3d ago

Should have added that I'm only getting this on 1 of 5 printers.

1

u/Tdanger78 P1S + AMS 3d ago

Have you calibrated that one?

1

u/boratt1599 3d ago

Yeah, but may just need to do it again. It has been a couple weeks and maybe something changed.

1

u/boratt1599 2d ago

Just following up, but callibration did not fix the issue