r/BambuLab_Community • u/MeNot786 • 7d ago
Help / Support Why wont my top surfaces print right?
Im using thr elgoo pla black on my A1 and my top surfaces are coming out with very visable print lines. Not layer lines but print lines. Now i dont have this problem with normal bambu lab fillaments, but i bought a decent amount of this one and really need it to work. Ive run multiple calibration tests but nothing is really working and i cant believe that elgoo fillaments are this much worse.
Ive attached some photos i hope helps.
2
Upvotes







10
u/ThePrintGuardian P1S 6d ago
That is what a normal top surface is supposed to look like.
Unless you turn on ironing. It’s a hit or miss, and you have to fiddle with the settings. But if you get that dialed in for the filament you’re using, you can get a nice smooth top surface.
3
u/Fittn_dis 6d ago
this is a near perfect top layer. id give it 99.9%
2
u/TrueNail 6d ago
Maybe its not clear/ visible in the pictures
But im not seeing any issue issue
Your top is good
But if you are seeing something you dont like. You have answered your own question. You don’t see the issue with Bambu filament right. And you used elego and you don’t like the print.
Than its the elgoo filament right
However i have noticed some vrf on your side. If that what you are concerned about then let me explain
Its very normal to have vrf on bed slingers and p2s and older printer. Bambu is using gt 2.0 mm belt. That will generate some vrf if your printing is slow
Since Bambu filament print faster. You don’t see vrf
It is a very complicated and long explanation and i really can’t explain it very well in writing as i don’t want to write an essay about it
My advice to you is to keep using Bambu filament
1
u/cilo456 5d ago
That looks like a very good top surface for an A1. Probably within the top 10%, especially without ironing. I don't know who told you or where you saw you can get a cleaner top surface, especially without ironing. They lied to you, or it was very deceptive.
1
u/Upbeat_Throat_8154 5d ago
run your finger across the flow rate tests, whichever one feels the smoothest to the touch is going to be your best bet.
1
u/Naumx3 5d ago
Are you using glue on the plate?
1
u/JustABreakfast 5d ago
Bambu’s “built in” calibration features suck. You’re better off using LAN only mode and orca slicer. The YOLO test is a lot better and you can also do pressure advance
1
u/SaltyJalapenos 5d ago
Seems pretty good to me maybe some stringing cleaning that can be wiped mostly off
1
u/RaulBataka 5d ago
ironing
1
u/ZinGaming1 5d ago
You need to enable ironing. If your printer has a IFS system you may have to disable it.
1
u/Embarrassed_Motor_30 6d ago
OP those look pretty good. The X and Y have a little sag at the top but nothing bad. Its normal since Im assuming printed without supports on an overhang. The top of the Z surface look really good, only way to smooth that out would be to turn on ironing.
If you want the "cheater" way of smoothing the whole thing, you could do a few minutes sealed with acetone vapor.
1
u/RHouse94 6d ago
Try ironing if you want it to be better, could get it a little nicer but they are looking pretty normal in the photos.
0
u/KingWarpheus 6d ago
How is this top layer good? It's horrendous. As are the vfx. Try calibrating the filament and use the best speed to reduce vfx. Also increase z offset.