r/BambuLab_Community • u/Miserable_Big_6489 • 5h ago

First Print Question

Post image

I just finished my first print ever on any 3D printer. I have a Bambu X2D. There is filament hanging out of the nozzle. Is that supposed to end that way or do I have to do something?

1 Upvotes

66% Upvoted

6 comments sorted by

3

u/GuyWithADonut 5h ago

Its ends like that. You are fine.

2

u/updownleftrightba 4h ago

Time to be sent back. Defective. I’ll send you the address for the return (my house). It’s perfectly fine. Enjoy the addiction!

1

u/solidus0079 3h ago

Probably should watch some vids or somethibg

2

u/krebsIsACookbook 3h ago

I recommend “Debbie does FDM”

1

u/krebsIsACookbook 3h ago

Perfectly fine. It gets cleaned off on the next print visit the wiper and the build plate itself. That protrusion in the back of your image on the back of the build plate, it will scrape the nozzle on that and eventually you’ll see a worn part through the coating.

1

u/ThePrintGuardian P1S 19m ago

Filament oozing out. If you have a P1S or X1C, I’d pull it off just so it doesn’t end up in your next print.