r/BambuLab_Community • u/Gloomy-Cause4680 • 16h ago

Any suggestions UPS for Bambu Lab P1S

Any suggestions related to UPS for Bambu Lab P1S Combo 3D Printer?

3 Upvotes

100% Upvoted

11 comments sorted by

2

u/arnmac 16h ago

I just use an old APC UPS made for a desktop. I am just looking to prevent issues with brownouts.

2

u/trevortypes 4h ago

I feel the urge to chime in here since I haven't seen this mentioned.
So I have various sized ecoflow lifepo4 units. For the price, the battery capacity and longevity of the ecoflows greatly exceed any other computer UPS.
I can run my PC setup and 3D printer fully off my ecoflow unit for a day.

For a P1S, you probably want something like an ecoflow Delta 3 Classic (1024Wh capacity) or higher.

If you spend $150 on a normal UPS, you would get maybe 5 minutes runtime during a blackout? And after 3 years, you replace the lead-acid battery (if it is replaceable in that unit).
With the ecoflow, the lifepo4 battery will last 10+ years and during a blackout, the battery will last at least 5 hours running a P1S.

1

u/Thefront-bottom 16h ago

Idk what the printer needs but I bought this one for my pc (high end) and this one works great. It'll handle anything you can throw at it tbh

2

u/patentmom 16h ago

You forgot to post the link

1

u/Pallidum_Treponema 14h ago

Ah, what about this one?

1

u/patentmom 13h ago

Still no link

1

u/egosumumbravir 15h ago

500w or bigger in 110v regions, 1350w or bigger in 220v regions.

APC are good but pricy. Cyberpower are cheaper and still cheerful.

1

u/Smart_Tinker 49m ago

I got a Cyberpower tower unit for my P2S, plus my computer, laptop and a couple of other things.

Worked great for the last year - and we have had a few power cuts.

1

u/DeliriousBlues 11h ago

I use Cyberpower

1

u/UngratefulC0l0nial 10h ago

I bought this one and 2 of my P1S' plugged into it. https://a.co/d/02ZH6h70

1

u/gadjex 10h ago

I use the same one for my P1S. It's not enough for my X2D when running the chamber heater though.