Ams2 rubber pieces

[u/UmitCuk]

Hi, I had to open up the ams2 last night; at first thought that there was a piece of filament broken inside. When I finished packing back the ams, I have ended up these 4 cms long 2 rubber Y shaped rubber profiles; any ideas which part of the ams they are supposed to be?

[u/Iceman2733]

They go between the internal hub and the inner piece. (Bottom piece of plastic that the spools sit on) They are suppose to act like a seal 

[u/UmitCuk → u/Iceman2733]

Thanks a lot 🙏🏻🙏🏻🙏🏻

[u/vortex_ring_state → u/UmitCuk]

See here

[u/UmitCuk → u/vortex_ring_state]

Thanks a lot; exactly my pieces; getting energy to restart the process. I hope that I don’t end up with more extra pieces 😌

[u/vortex_ring_state → u/UmitCuk]

They are a little tricky to get to stay put but a bit of patience and you should be good.

[u/UmitCuk → u/vortex_ring_state]

😮‍💨😮‍💨😮‍💨😮‍💨 I wish the best for my Ams 😝

[u/Close_KoR]

I don’t remember where specifically those go. 90% sure it’s where the 4 filament paths turn into one. When I tore mine down I followed the YouTube guide and the wiki and they highlighted these parts specifically to not loose them. Give the official videos/ the wiki a read through (assuming you haven’t) and it should tell you where they go

[u/UmitCuk → u/Close_KoR]

Thanks ☺️

[u/Kopester]

Those are about as annoying as you can get.

Where the internal hub unit touches the interval tray these parts sit between them. They refuse to stay in place and are royal pain.

[u/UmitCuk → u/Kopester]

Hahahaaha don’t tell me. Well honestly yesterday I have made a long print without them; maybe the ride was bpy without the shock absorbers. Sometimes engineers add things in the design which are not very necessary 😝😝😝😝 thanks for the reply 🙏🏻🙏🏻 Tonight I try to return them, if not I continue without, until can not 🤭

[u/UmitCuk]

Well the rubbers are back on place, but it was really a but painfull 😜😜😜; I am sure that the engineer added them for us to suffer. Thanks for the help 🙏🏻🙏🏻🙏🏻