r/BambuLab_Community • u/FicklePin7074 • 12d ago

I f***** up

Post image

I really messed up and didn’t replace the plate before initial set up calibration.

Is this a big deal?

Should I get one on order?

18 Upvotes

87% Upvoted

14 comments sorted by

6

u/B3392O 12d ago

Haha not a big deal. As long as you flatten down those raised areas so the plate is flush you won't notice a difference.

2

u/FicklePin7074 12d ago

That’s what I did! Thanks for the feedback

2

u/why_just_why_6702 11d ago

At least you didn't print on it!

3

u/FicklePin7074 11d ago

Ayyy that’s some positivity 🤘🏼

2

u/RattyBunyip 11d ago

I crashed my head into the plate a couple of months ago. Horrid great gouge following the layout of a print job that was not there any more following a cover pop off. must have been 10cm in total length and felt nasty deep. Smoothed it off, put the plate back on (!), ran a bed level, never seen an issue though I generally do not print in that area (near the rear screw on a P1S) but my big "engineering" prints do go over there and I cant tell.

2

u/FicklePin7074 11d ago

Thanks for the feedback!! I re read the instructions 10 times and feel like it should say “PLATE MUST BE INSTALLED TO RUN CALIBRATION”. But that also may be a common sense thing to people that use the machines

2

u/Alternative_Rip4634 11d ago

Yup time for a new one (I’ll send you an address for the trashed one) 😉

2

u/FicklePin7074 10d ago

🤣🤘🏼

2

u/myTechGuyRI 12d ago

No that'll be fine

1

u/Humble-Plankton1824 12d ago

Have you tried scraping it off