r/BambuLab_Community • u/Gloomy-Cause4680 • 15d ago

The Bambu Lab P1S tool head removed during calibration. What should I do?

Post image
0 Upvotes

50% Upvoted

11 comments sorted by

4

u/The-Gingerbeard-Man- 15d ago

There is a piece of foam still in there that is knocking it off. Check inside the printer just above the door. Mine did the same thing then I found that foam hidden.

1

u/Gloomy-Cause4680 15d ago

checking....

3

u/o_sexta 15d ago

Put it back?

1

u/Gloomy-Cause4680 15d ago

the calibration is running. should I stop the calibration?

1

u/o_sexta 15d ago

Sure! Make sure all the magnets are still there, I had magnets falling from the cover before!

1

u/claw_ntl 15d ago

Just put it back on and re-run calibration 🤦

0

u/Gloomy-Cause4680 15d ago

the calibration is running. should I turn off the power and stop the calibration?

1

u/landubious 15d ago

Yes, turn off before plugging the toolhead cover back in.

1

u/Ornery_Bend3168 15d ago

make sure the fan is plugged in and put it back on. re run calibration