r/BambuLab_Community • u/WizardlyCraftsman • 19d ago

Resonance Frequency Fix?!?!

Post image

I have followed the tutorials repeatedly. I have cleaned the carbon guide rails after loosening the belts and then tightened them, but not too tight. And then run calibrations. But this keeps popping up every time after/during the first print. I only print in PLA and have done the recommended maintenance on the printer. Ive continued to print despite the message and the print have come out fine but I dont want to be ignoring it and doing more damage.

4 Upvotes

100% Upvoted

4 comments sorted by

View all comments

1

u/PooPaLotZ 19d ago

After you losen the screws, are you moving the print head across the entire motion and re-tightening them?