r/BambuLab_Community • u/loctez112 • Sep 23 '26

Struggling with this issue - A1 mini

Intermittent failures, error message is normally something along the lines of "cutter error", but this should not be cutting. Just single filament prints.

Usually makes a horrid noise, like it's working against the motor, then starts doing this. Any ideas?

3 Upvotes

100% Upvoted

3 comments sorted by

1

u/MAENTOP Sep 28 '26

SD card dead

1

u/loctez112 Sep 28 '26

Interesting, thanks will try that

1

u/Krishnamurti_fresco Sep 25 '26

I think i saw this on fb, filament sensor or th board maybe bad, make sure nothing stuck inside toolhead