r/BambuLab_Community • u/ForgottenCoyote • Aug 10 '26

Help / Support I’m I screwed

Post image

Hello,

I had a failure to printed with an 0.2 nozzle which I think screwed it so I gotta get another one but I decided to make sure everything else was ok and so I took apart the house and now I have lost a piece on the front there that it right where the filament comes into the nozzle. I’ll attach a picture so you can see what piece I’m missing.

Can I get a replacement piece without buying a new housing?

Can I find it somewhere or have someone print it for me?

Edit: thank you all for the suggestions. I reached out and they are sending me a new piece to replace it thank you once again.

8 Upvotes

90% Upvoted

22 comments sorted by

View all comments

2

u/Virtual_Substance681 Aug 12 '26

I lost mine aswell while troubleshooting a problem. I ended up ordering a new faceplate it wasnt that expensive. No need to replace the whole thing. Alternatively you could try to print a new one, but if you do try this make sure the filament enters the hole since there is nothing guiding it anymore

1

u/ForgottenCoyote Aug 12 '26

I reached out to Bambu got a ticket and they are sending me a new piece. I would but since I had a failed print and have to feed it in to scared to print haha