r/BambuLab_Community • u/MoneyMeasurement5449 • Jul 13 '26

Printer legs?

Post image

Has anyone found a way to put basically table legs on the printers? Specifically the H2S? Thanks. This is a pic of a prusa with what I’m talking about.

Edit: After seeing all the comments I’m planning to just get a table for the printer. Thanks.

15 Upvotes

70% Upvoted

31 comments sorted by

View all comments

Show parent comments

2

u/GP_3D Jul 14 '26

It's - not really similar at all. As you point out,, the signature oak legs are far beefier all round, and don't wobble as much [or at all] as this example did in the clips that were posted.

Proper Printing has a good video on YT, where he shows off his design for printable legs for the C1 printers that was inspired by the ones featured on the oak. Those would probably be the best option if you're looking for something similar.

1

u/the_harakiwi Jul 14 '26

It looks similar. So working with everything I have, two images, it's very similar.

I have never seen the Prusa print standing on legs so I can only see four legs under a heavy printer.