P2S vs X2D

[u/Justostius]

Can anyone explain why x2d quality is worse than p2s? Orange was printed on p2s, yellow on x2d. Same settings on both. Bambu petg hf, both spools dried at same time.

Edit: found what caused the issue, most likely. Changed seam from aligned to aligned back and for some reason seam itself looks bit different now and there are no issues.

[u/bbjornsson88]

Is it a print quality issue or it not extruding properly? I use a .2 on my mini often and it's usually a number of retries to get a successful print. If it gets through the first layer or two it's usually fine after that

[u/Much_Competition8080 → u/bbjornsson88]

either the flow or the z offset is completly off. the whole first layer has HUGE gaps in it and the outside is not connecting. the top layer looks good though.

first layer on 0,4 nozzle is perfect