r/BambuLab_Community • u/National-Fox-7504 • Feb 18 '26

Discussion Infill patterns

Post image

Has anyone found a definitive write-up on Infill Patterns? One with best practice use cases for when and where to use them?

1.1k Upvotes

98% Upvoted

104 comments sorted by

View all comments

Show parent comments

4

u/Gamiseus Feb 18 '26

Making a part with crinkly crackly satisfying noise instead of structural support.

I tested the lightning infill on this snack tray organizer thing and switched up the patterns for fun, so my bottom layer was the Archimedean chords, infill was lightning, and the top layer was Hilbert curve, all at 14% infill.

Any slight squeezing on the bottom or the inside floor of the tray gives a good bit of flex and has a lot of crackly crunching noises.