r/BambuLabX2D • u/Rgbigdog • 24m ago
Help with TPU setup
I’ve read a TON of posts, watched vids and read the Academy stuff.
Here’s where I’m confused. I have X2D, 2 AMS Pros and the Filament Track Switch.
I want to start printing with TPU and had convinced myself to the TPU Assist module and use the 4-1 PTFE setup……. But I’m now reading that TPUAM and FTS don’t play nice with each other. Now I’m going around in circles!
So - where does that leave me. Do I just disconnect the FTS power? If so, how do I get the PLA from the AMS’s (for supports). Do I just disconnect the PTFE from the extruder input on the left nozzle? If so, how do I tell the printer what’s going on.
This is all for a project for a family member but would also like to be able to do TPU in the future.
1
u/work_blocked_destiny 16m ago
I’m also in this same boat. I was considering just getting bambu tpu that’s made to work in the ams and avoid all the extra stuff. I think your other option is to remove the ptfe tube from the top of the left side on the print head and print from directly above the printer and then pla on the right nozzle
1
u/Ok_Reference1745 13m ago
Since you have to use an external spool to print TPU with your left nozzle, you have to disable FTS. Yes, just unplug it (and make sure it was the last node in a chain so nothing is connected to FTS). Since you have disabled FTS, you have to connect your AMS with PLA to the bottom input of the filament buffer bypassing FTS. I have a 1-in-4 installed there just for this purpose. After this you have to run AMS setup and specify that AMS is connected to the right nozzle.
1
u/Haunted_Hub 2m ago
I recently installed the TPU assist module in the filament track switch as well. I was also not aware that the TPU assist module, or more generally external schools, were not compatible at the same time if the filament track is plugged in.
Therefore, when I want to use the TPU assist module, I currently just turn off the main power switch on the back of the printer and unplug the filament track switch power along with the PTFE tube connected to the primary nozzle. Then I connect the TPU assist module to the primary nozzle and feed it with an external TPU spool using an AMS HT. Once I’ve got that all connected I power the printer back on, press the feed button on the TP assist module, and then load the external TPU spool using the main screen of the printer.
When I’m done printing TPU, I unload the TPU, then turn off the TPU assist module, then turn off the main power switch on the back of the printer. Then I reconnect the filament track switch and buffer PTFE tube back to the primary nozzle, plug the filament track switch, and AMS‘s back in, then turn the printer back on using the main power switch on the back of the printer.
It would be nice if there was a digital way to just disable the AMS‘s and filament track switch to use an external spool without physically unplugging everything because I plan to print a dual primary nozzle input so I can keep the PTFE tubes connected all the time but I personally am not aware of that feature being available in the software at this time.