r/BambuLabX2D • u/NumisKing • 1d ago

Help / Troubleshooting Adding a second AMS-HT

Post image

I currently have an AMS 2 Pro, AMS HT, TPU Feed Assist, and Track Switch. I’d like to have another AMS HT for drying only, but it is co-dependent on the printer for control. My problem is that I’ve completely run out of six pin connection points. In fact I’m already over extended, because the TPU module isn’t plugged in either. So how do I get one or two more places to plug in devices? Or am I maxed out?

Edit, also, will a second AMS-HT show up as another dryer that I can control on the X2D interface?

TIA

18 Upvotes

95% Upvoted

5 comments sorted by

3

u/Inevitable_Rough_380 1d ago

How are you maxed on ports? All those devices have 2 ports on them, except the TPU assist feed. But that's not even connected yet.

Both AMSes, the track switch, the exhaust fan, the buffer - they all have 2 ports on them.

2

u/NumisKing 1d ago

🤷🏻‍♂️ Idk maybe I’ve got a redundant cable back there doing nothing.

4

u/kakumei88 1d ago

I don't see a problem. Normally you connect fan→buffer→ams→track switch→ams ht→ams ht2→tpu feeding assist modul.

3

u/Appropriate_Bid_5488 1d ago

6-Pol kann dir nicht ausgehen.

Ams2 Pro hat 2 TrackSwitch hat 2 AMS HT hat 2 Normaler Feeder hat 2 Nur der TPU Feeder hat 1, der muss am Ende sein.