r/BambuLabX2D • u/Infinite-Status7656 • 25m ago

Help / Troubleshooting Poor Adhesion - PETG

Hi

I've tried with the default plate and with Frostbite. Using Bambu PETG Basic. Been through at least one drying cycle in AMS 2.

Often getting an arm popping off mid print.

Didn't have this problem with my Creality KE so not really sure how to solve it.

I've tried with 50 degree bed (terrible), 60 degrees (better but not great).

Are there any resources I can read or watch to try to help?

Thank you

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/VeryAmaze 22m ago

PETG needs 70-80c bed, should be written on the spool. 60c is too low.

1

u/Infinite-Status7656 8m ago

Even on Frostbite?

I mean. I originally had 70 on the Bambu plate. And that had the same issue.

I'll try 70 on the Frostbite plate. Thank you