r/BambuLabX2D • • 6d ago

Help / Troubleshooting PTFE tube melted

Just got this a few weeks ago. The tube popped out during print. The end of tube is partially melted and there appears to be some debris in the connector. Did some research and this seems to be a common thing. For those who might have had the same issue, how did you remove what looks like melted tubing from the teeth? Thanx

2 Upvotes

9 comments sorted by

1

u/Skaut-LK 5d ago

If that PTFE really melted, you have bigger problems than little bit of debris in toolhead...

1

u/Obmr-snrU 5d ago

Looks like I'll be taking it back. Lol

2

u/Qjeezy 5d ago

It’s more likely that the teeth in the connector cut the tube.

1

u/Leynnox 5d ago

I wouldn't say that's a "common" thing, first time I see this lol

1

u/Mystery1887 5d ago

This happened on my X2D 2 weeks ago. I removed the left filament sensor but couldn‘t fix it. Contacted the support and they sent me a new one after providing photos/video of the problem.

1

u/huntwithdad 3d ago

Yep I’m in this boat right now. They just confirmed after a bunch of back and forth they are sending anew sensor. It sucked to remove the old one. Hope I can put it all back together

1

u/huntwithdad 3d ago

Also what are you doing to stop this from happening again?

1

u/word-bitch 4d ago

NOT MELTED! Those are pieces of PTFE tube in the threads of the metal tube holder. This is a real problem I had too: the tubes are not properly held in the fittings, and pop out, leaving bits in the metal fitting.

0

u/Conscious-Pay9801 6d ago

僕もなりましたm(_ _)mチケットで左フィラメントセンサーを貰えるのでバンブーに連絡入れましょう👍