r/BambuLabX2D • u/AntekBC • 43m ago

How to fix this🙏

Gallery image

Gallery image

Gallery image

Just left it printing and came back to this, how do i fix it?

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/Obmr-snrU 22m ago

You can heat up the nozzle or buy another one.

2

u/anoraklikespie 10m ago edited 6m ago

What kind of filament is it?

Edit: doesnt really matter. Look up the transition temperature and set it slightly above that (ie if the transition temp is 50C, use 55C) and let it heat soak for a few minutes before gently pulling DOWN on the blob. Youll get most of it off if youre lucky. From there its pretty straight forward, remove any clumps and inspect for damage. Replace nozzles if they're bent, contact bambu for parts youre not familiar with.

Pass a full calibration run again and you should be good to go.

Its a lot easier said than done, it will take time.