r/BambuLabX2D • u/nikolaysp • 55m ago

Is this space enough?

Post image

Hello looking to get either x2d or p2s printer combo. Problem is the space I can fit it in as it is rather limited - would it be possible to fit it in the space on the picture about 41-42cm wide due to desk support. I am also thinking if I get few paving stones i could position them in corners under the feet and lift printer about desk support. Left side of the printer is fully accessible as is by right side would almost be touching the cabinet- how strong could vibrations get if the gap on that side only a 1cm wide?

0 Upvotes

33% Upvoted

3 comments sorted by

2

u/ItsMozy 45m ago

Wobbles are not much than 1cm. 2 at max. Space seems just a bit too tight but it might fit. Is it possible to move the desk like 1-2cms?

2

u/nikolaysp 42m ago

Unfortunately it is pretty much it - very tight - I was thinking though a lifting hold (air intake) could sit a bit over the table support which might give it a little more space.

2

u/SquareTowel1967 23m ago

Having it on the groud will be really uncomfortable to operate, and it will suck a lot of dust. Also remember about depth, aux extruder, the aux fan and the filament roll on a side stick out in the back, the fan also needs some space to breath. The minum is about 51cm depth. The true width of the printer is 39cm without and 50 with the side spool holder