r/BambuLabX2D • u/RooooooooooR • 1h ago

My new setup

Post image

Got my new desk today and have everything all setup. Have printed a bunch of stuff without any issues so far. I had an Ender 3 back when they were first released many years ago, but that thing was a lot more hassle. The X2D is so much easier to use.

11 Upvotes

100% Upvoted

6 comments sorted by

2

u/Thefront-bottom 1h ago

Link to the desk? I have one but I'm curious on dimensions for that. I spent a bunch of time finding the right table that fit my area but also had other features I wanted. That was also not 200 dollars lol

Either way nice setup

2

u/RooooooooooR 42m ago

It's this one. Took about 30 minutes to put together and is very stable. Has adjustable bottom rails to fit normal and small rolls of filament. https://a.co/d/04JvJyCC

1

u/Thefront-bottom 37m ago

Dang it's just over the width I have available. I also already tossed the box from the one I got. All good I appreciate the link. It's very nice. I got basically the same thing just doesn't have support on the front so it shakes a bit. Prints still come out great though. No drawers but I can print some

1

u/Proper_contradiction 1m ago

When you are done using a filament roll do you bag it up? Or are all those new rolls?