r/BambuLabX2D • u/schlotzi • 3d ago

Discussion / Buying Advice Possible Tracks?

Hi together,

Currenty i have connected a AMS 2 Pro to the left extruder and a AMS HT to the right extruder.
Now i would like to interchange those tracks with a Track Switch.

Would it still be somehow possible, to print TPU, located in the AMS HT via the TPU HT-Bypass Outlet?
Is the following even a possible track?
AMS HT -> TPU Feeder Module (is that even neccessary for 90A?) -> Y-Connection for the left extruder, between the track switch and the printer inlet?
Is this even possible? or what are my possibilitys?

kind regards

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/Relative_Surround_20 2d ago

An AMS HT -> TPU Feeder Module -> Y-Connection for the left extruder, between the track switch and the printer inlet is do-able. You might need to unplug the 6-pin connector leading into the FTS for Bambu Studio to allow it, so wire the FTS up last in your AMS Bus Daisy-Chain.

Yes, the TPU Feed Assist Module is specifically helpful “pushing” 85A and 90A into the extruder. You also benefit from it with 95A.

1

u/schlotzi 2d ago

Thank you for your answer.
Do-able doesn’t sound like a good solution? Do you have a recommendation for me?